LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Automatic Transmission Servicing) >> Removal & Installation >> Filler Tube (4L60-E) >> Removal

Filler Tube (4L60-E): Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission fluid level indicator from the fluid fill tube. Remove the bolt securing the transmission fluid fill tube bracket to the engine. Raise and support the vehicle. Remove the bolt securing the transmission fluid fill tube bracket to the transmission. See Figure .
  2. Remove any dirt from the transmission where the fluid fill tube enters the transmission case. Remove the transmission fluid fill tube from the transmission.
  3. Pull the tube upward from the transmission. Remove the transmission fill tube seal. Clean the metal parts using solvent. DO NOT allow the solvent to enter the transmission. Dry the parts using compressed air.
scientia non olet · About LEMON Manuals