LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 549 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Sunroof Panel Window (ZRX/EXTREME w/ CF5) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the garnish molding to the headliner.
  2. Ensure the sunroof switch wiring is positioned properly through the garnish molding.
  3. Install one short front screw (1) and install one long rear screw in order to hold the garnish molding (3) in position.
    Fig 1: Garnish Molding
    G01478152Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the remaining screws including the one other short screw next to the motor/actuator.

    Tighten 

    Tighten the screws to 1.5 N.m (13 Ib in).

  5. Install the 8 sunroof panel window garnish molding screw covers.
    Fig 2: Sunroof Panel Window Garnish Molding
    G01478153Courtesy of GENERAL MOTORS CORP.
  6. Position the sunroof switch (4) to the motor/actuator trim cover (5).
  7. Locate switch to cover in order to secure.
    Fig 3: Sunroof Switch
    G01478154Courtesy of GENERAL MOTORS CORP.
  8. Position motor/actuator trim cover to the sunroof panel window garnish molding.
  9. Install the motor/actuator trim cover screw (2).

    Tighten 

    Tighten the screw to 1.5 N.m (13 Ib in).

  10. Install the motor/actuator service cover.
    Fig 4: Motor/Actuator Service Cover
    G01478155Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals