LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 549 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Side Door Lock Pillar (CF5) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the front side door lock pillar garnish molding to the vehicle. Feed the seat belt through the garnish molding.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the upper and the lower front seat belt anchor bolts.

    Tighten 

    Tighten the screws to 70 N.m (52 Ib ft).

  3. Install the front and the rear door sill trim plates. Refer to DOOR SILL PLATE REPLACEMENT .
    Fig 1: Front Side Door Lock Pillar Garnish
    G01478145Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals