LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 544 (Stationary Window System) >> Description and Operation >> Rear Window Defogger Description and Operation >> Rear Window Defogger Operation

Rear Window Defogger Operation

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

Battery positive voltage is supplied to the RR DEFOG relay switched input. Ignition voltage is supplied through the IGN E fuse, in the underhood fuse block, to the RR DEFOG relay coil. When you start the engine, and depress the rear window defogger switch.

The HVAC control assembly illuminates the rear window defogger indicator and energizes the RR DEFOG relay by grounding the control circuit of the relay. This allows battery positive voltage from the relay switched input through the switch contacts and out the relay switched output to the RR DEFOG fuse and then to the rear window defogger grid.

Ground for the rear window defogger grid is provided by G420.

When you start the engine and press the rear window defogger switch for the first time, the defogger cycle lasts for 10 minutes. Further operation results in 5 minute defogger cycles. The defogger cycle resets to 10 minutes when you cycle the ignition to the OFF position and then start the engine.