LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 543 (Exterior Trim) >> Repair Instructions >> Molding Replacement -Front Fender Body Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the screw securing the molding to the fender.
  2. Remove the body side molding.
    1. Heat the molding using a J 25070.  Hold the heat gun approximately 152 mm (6 in) from surface.

      Apply heat using a circular motion for approximately 30 seconds.

      Important:  Be careful not to scratch or chip the paint.

    2. Peel the body side molding from the panel surface using a flat-bladed tool.
    3. Remove all adhesive from the fender and the back of the molding using a 3M™ scotch brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
    4. Clean the body panel using Varnish Makers and Painters (VMP) naphtha.
    Fig 1: Removing Screw Securing Molding To Fender
    G01477336Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals