LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 540 (Theft Deterrent System) >> Diagnostic Information and Procedures >> Diagnostic System Check - Theft Deterrent >> Test Description

Test Description

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2. Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.
  2. 5. Tests for an open in the Passlock™ sensor signal circuit, which may not set a DTC (B2958) under certain conditions.
  3. 6. The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.
  4. 7. The presence of DTC P0601, P0602, or P0604 indicates an internal fault in the PCM.
  5. 8. The presence of DTC B1000 indicates an internal module fault.
  6. 9. The Presence of DTC P0562, P0563, or P0621 indicates a low or high voltage condition.
    Fig 1: Diagnostic System Check - Theft Deterrent (Step 1 To 2)
    G01476743Courtesy of GENERAL MOTORS CORP.
    Fig 2: Diagnostic System Check - Theft Deterrent (Step 2 To 2)
    G01476744Courtesy of GENERAL MOTORS CORP.
    Fig 3: Scan Tool Data List
    G01476745Courtesy of GENERAL MOTORS CORP.