LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 538 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Console Replacement - Front Floor (Full Length (Manual Trans)) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the console to the vehicle.
  2. Connect the electrical connector, if equipped.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the nuts that retain the console to the vehicle.

    Tighten 

    Tighten the nuts to 10 N.m (88 Ib. in).

    Fig 1: Installing Console To Vehicle Retaining Nut
    G01476677Courtesy of GENERAL MOTORS CORP.
  4. Install the storage compartment to the vehicle.
    Fig 2: Installing Storage Compartment To Vehicle
    G01476678Courtesy of GENERAL MOTORS CORP.
  5. Install the trim plate to the console.
  6. Install the screws that retain the trim plate to the console.

    Tighten 

    Tighten the nuts to 1.9 N.m (17 Ib. in).

  7. Install the cup holder insert.
  8. Install the shift control lever. Refer to CONTROL LEVER AND/OR BOOT REPLACEMENT in Manual Transmission - NV 1500 or to CONTROL LEVER AND/OR BOOT REPLACEMENT in Manual Transmission - NV 3500.
    Fig 3: Installing Trim Plate To Console Retaining Screws
    G01476679Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals