LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 538 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Closeout/Insulator Panel Replacement - Instrument Panel (I/P) Lower >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the center console from the vehicle if equipped with RPO code YC7 (GMC Envoy). Refer to CONSOLE REPLACEMENT - FRONT FLOOR (FULL LENGTH (AUTO TRANS))  or CONSOLE REPLACEMENT - FRONT FLOOR (FULL LENGTH (ENVOY))  or CONSOLE REPLACEMENT - FRONT FLOOR (NON-FULL LENGTH)  or CONSOLE REPLACEMENT - FRONT FLOOR (FULL LENGTH (MANUAL TRANS)) .
  2. Remove the screws that retain the instrument panel sound insulator to the following components:
    • The knee bolster
    • The instrument panel
    • The heater assembly
    • The floor duct
  3. Remove the instrument panel sound insulator from the vehicle.
  4. Disconnect the electrical connector from the accessory power outlet, if equipped.
    Fig 1: Closeout/Insulator Panel - Instrument Panel Lower
    G01476620Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals