LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 538 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Bracket Replacement - Steering Column >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake pedal to the steering column support. Refer to BRAKE PEDAL in Hydraulic Brakes.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the steering column support bracket fasteners.

    Tighten 

    • Tighten the nuts to 25 N.m (18 Ib. ft).
    • Tighten the bolts to 25 N.m (18 Ib. ft).

  3. Install the brake switch. Refer to STOPLIGHT SWITCH in Hydraulic Brakes.
  4. Install the brake booster pushrod to the brake pedal. Refer to VACUUM BRAKE BOOSTER in Hydraulic Brakes.
  5. Install the clutch master cylinder pushrod to the clutch pedal, if equipped. Refer to CLUTCH PEDAL REPLACEMENT in Clutch.
  6. Install the instrument panel. Refer to INSTRUMENT PANEL (I/P) CARRIER REPLACEMENT .
    Fig 1: Steering Column Support Bracket Fasteners
    G01476635Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals