LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 535 (Wiper System And Washer System) >> Repair Instructions >> Hose Replacement - Rear Window - Washer Nozzle (Body to Liftgate) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upper rear garnish molding. Refer to GARNISH MOLDING REPLACEMENT -- REAR UPPER in Interior Trim.
  2. Remove the body side trim panel. Refer to TRIM PANEL REPLACEMENT -- BODY SIDE (STANDARD CAB PICKUP) or TRIM PANEL REPLACEMENT -- BODY SIDE (EXTENDED CAB PICKUP) or TRIM PANEL REPLACEMENT -- BODY SIDE (2-DOOR UTILITY) or TRIM PANEL REPLACEMENT -- BODY SIDE (4-DOOR UTILITY) or TRIM PANEL REPLACEMENT -- BODY SIDE (CREW CAB) in Interior Trim.
  3. Remove the liftgate door sill plate. Refer to DOOR SILL PLATE REPLACEMENT -- LIFT GATE or DOOR SILL PLATE REPLACEMENT -- END GATE in Interior Trim.
  4. Disconnect the hose from the body harness connection.
  5. Disconnect the hose from the liftgate harness connection.
  6. Remove the hose clips from the vehicle body.
  7. Remove the hose assembly.
    Fig 1: Removing Hose Clips From Vehicle Body
    G01476399Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals