LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 528 (Automatic Transmission Service, Removal & Installation - 4L60-E) >> Repair Instructions >> Manual Shift Shaft Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Remove the Park/Neutral Position (PNP) Switch. Refer to PARK/NEUTRAL POSITION SWITCH REPLACEMENT .
  3. Be sure that the jackscrew for J 43911  is backed off and will not interfere with installation of the removal tool. Slid the seal remover tool over the selector shaft (2) with the threaded end of the tool towards the seal.
  4. Rotate the removal tool so that the threads on the end of the tool engage the steel shell (1) of the seal. Use a wrench to be sure that the removal tool is firmly attached to the seal shell.
    Fig 1: Removing Manual Shift Shaft Seal With Selector Shaft Seal Remover
    G01979998Courtesy of GENERAL MOTORS CORP.
  5. Rotate the jackscrew in the clockwise direction to remove the seal from the bore. Discard the seal that was removed.
scientia non olet · About LEMON Manuals