Conditions for Running the DTC

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

No TP sensor DTCs P0122 or P0123.
No VSS assembly DTCs P0502 or P0503.
No TCC solenoid valve DTC P0740.
No 1-2 SS valve DTC P0753.
No 2-3 SS valve DTC P0758.
No 3-2 SS valve assembly DTC P0785.
No TCC PWM solenoid valve DTC P1860.
The engine speed is greater than 450 RPM for 5 seconds.
The engine is not in fuel cutoff.
The engine torque is 54 N.m (40 lb ft) or greater.
The TP angle is 12-50 percent.
The vehicle speed is 56-112 km/h (35-70 mph).
The speed ratio is 0.64-0.95, the speed ratio is the engine speed divided by the transmission output speed.
The engine speed is 1,500-3,500 RPM.
The gear range is D4.
The commanded gear is not 1st gear.
The TFT is between 20-130°C (68-266°F).
The shift solenoid performance diagnostic counters are zero.