LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 527 (Tires And Wheels) >> Repair Instructions >> Tire and Wheel Removal and Installation >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle with safety stands. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Remove the wheel hub cap, if equipped.
  3. Remove the wheel nuts. Mark the location of the tire and wheel assembly to the hub assembly.
  4. Remove the tire and wheel assembly.
  5. Clean the wheel nuts, studs, and the wheel and rotor mounting surfaces.
    Fig 1: Tire & Wheel Assembly
    G01467799Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals