LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 526 (Front Suspension System) >> Repair Instructions >> Wheel Stud Replacement (4WD Pickups and Utilities) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle with safety stands. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Remove the tire and the wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  3. Remove the rotor. Refer to BRAKE ROTOR -- FRONT in Disc Brakes.

    Important:  Do not hammer on a wheel stud.

  4. Remove the wheel stud bolt using J 43631  .
    Fig 1: Wheel Stud Bolt
    G01467718Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals