LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 523 (Steering Linkage (Non-Rack & Pinion)) >> Repair Instructions >> Idler Arm Replacement (RWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle with safety stands. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Remove the idler arm mounting bolts and nuts from the frame.
    Fig 1: Removing Idler Arm Mounting Bolts & Nuts From Frame
    G01467337Courtesy of GENERAL MOTORS CORP.

    Important:  Use the proper tool in order to separate all ball joints.

  3. Remove the relay rod stud nut.
  4. Disconnect the relay rod from the idler arm using J24319-B. 
  5. Remove the idler arm.
  6. Inspect the ball stud threads for damage.
  7. Inspect the ball stud seal for cuts or other damage.
  8. Clean the threads on the ball stud.
  9. Clean the threads on the ball stud nut.
    Fig 2: Disconnecting Relay Rod From Idler Arm
    G01467338Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals