LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Automatic Transmission - Service Information) >> Removal & Installation >> TFP Manual Valve Position Switch >> Installation

TFP Manual Valve Position Switch: Installation

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Carefully install the fluid pressure manual valve position switch. Handle the switch carefully, the fluid pressure manual valve position switch is very delicate. See Figure . Install the control valve body bolts (375, 379, 381) that mount the fluid pressure manual valve position switch to the control valve body (300).
  2. Tighten the control valve body bolt (375) to 106 INCH lbs. (12 N.m). Tighten the control valve body bolt (379) to 106 INCH lbs. (12 N.m).
  3. Tighten the control valve body bolt (381) to 70 INCH lbs. (8 N.m). Connect the transaxle wiring harness. Install the case side cover. See CASE SIDE COVER  .
scientia non olet · About LEMON Manuals