LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Automatic Transmission - Service Information) >> Removal & Installation >> Park/Neutral Position Switch >> Removal

Park/Neutral Position Switch: Removal

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply the parking brake. Block the wheels. Shift the transmission into Neutral. Remove the throttle body air inlet duct. Use a flat-blade tool in order to remove the shift cable from the manual control lever. See Fig 1 .
  2. Remove the electrical connectors. Remove the manual control lever. Remove the PNP switch bolts. See Figure . Remove the PNP switch.
Fig 1: Removing & Installing Shift Cable At PNP Switch
G00087760Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals