LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Automatic Transmission - Service Information) >> Removal & Installation >> Case Extension Housing >> Installation

Case Extension Housing: Installation

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform a differential carrier end play inspection. See appropriate OVERHAUL article in AUTOMATIC TRANSMISSIONS. If removed, install the drive axle seal. Install the case extension housing with the axle seal and the O-ring. See Figure .
  2. Install the case extension housing bolts. Tighten the case extension housing bolts to specification. See TORQUE SPECIFICATIONS  . Install the vehicle speed sensor. See VEHICLE SPEED SENSOR  .
  3. Install the transaxle brace. See TRANSAXLE BRACE  . Connect the right drive axle to the transaxle. See appropriate article in DRIVE AXLES. Lower the vehicle.
    4. WARNING: DO NOT overfill the transaxle. The overfilling of the transaxle causes foaming, loss of fluid, shift complaints, and possible damage to the transaxle.
  4. Adjust the fluid level. See CHECKING FLUID LEVEL & CONDITION  under LUBRICATION. Inspect for completion of the repairs. Inspect for fluid leaks.
scientia non olet · About LEMON Manuals