Removal Procedure
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Remove the oil level indicator.
- Remove the front differential assembly. Refer to DIFFERENTIAL CARRIER ASSEMBLY REPLACEMENT in Front Drive Axle
- Remove the starter. Refer to STARTER MOTOR
- Remove the transmission cover.
- Remove the oil pan drain plug and drain the engine oil into a suitable container.
- Remove the remote oil filter pipe adapter. Refer to Oil Filter Adapter Replacement .
- Remove the bolt holding the remote oil filter inlet and outlet hose clip to the oil pan.
- Remove the stud holding the bracket for the starter wire harness and if equipped, the transmission oil cooler pipes.
- Remove the access plugs for the oil pan rear nuts.
- Remove the transmission to oil pan bolts (automatic transmission shown).
- Remove and discard the engine oil level sensor (if applicable)IMPORTANT: The low oil level sensor is not reusable. Use a NEW low oil sensor.
- Remove the oil pan bolts and nuts.
- Remove the oil pan.
- Remove the oil pan gasket.
- Discard the oil pan gasket.
- Clean all sealing surfaces on the engine and the oil pan.