LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 516 (Engine Mechanical - 4.3L (LU3)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Tensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the drive belt tensioner assembly.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the attaching bolt.

    Tighten 

    Tighten the tensioner assembly bolt to 50 N.m (37 lb ft).

  3. Install the drive belt. Refer to Drive Belt Replacement   .
    Fig 1: Drive Belt Tensioner Assembly
    G01977349Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals