LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 516 (Engine Mechanical - 4.3L (LU3)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Front Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the exterior of the seal with clean engine oil.
  2. Use the J 35468  with a hammer in order to install the crankshaft front oil seal.
  3. Inspect to ensure the crankshaft front oil seal is flush and square to the engine front cover.
  4. Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement   .
    Fig 1: Using J 35468
    G01977555Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals