Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma and 2003 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the engine mount stud and the bolts.
Tighten
- Tighten the engine mount bolts to 54 N.m (40 lb ft).
- Tighten the engine mount stud to 55 N.m (41 lb ft).
  
  Fig 1: Installing Engine Mount Stud And Bolts
  Courtesy of GENERAL MOTORS CORP.
Install the engine mount through-bolt.
Tighten

Tighten the engine mount through-bolt to 45 N.m (33 lb ft).
Remove the engine lifting device.

Fig 2: Installing Engine Mount Through-Bolt
Courtesy of GENERAL MOTORS CORP.
Raise the vehicle. Refer to JACKING AND LIFTING in General Information.
Working through the wheelhouse, install the generator rear brace.
Install the nuts holding the brace to the intake stud and the stud on the engine.
Install the bolt holding the brace to the rear of the generator.
Tighten

Tighten the generator rear brace nuts and bolt to 25 N.m (18 lb ft).

Fig 3: Installing Generator Rear Brace
Courtesy of GENERAL MOTORS CORP.
Install the transmission support brace.
Tighten

Tighten the transmission support bolts to 50 N.m (37 lb ft).

Fig 4: Installing Transmission Support Brace
Courtesy of GENERAL MOTORS CORP.
Install the right fender wheelhouse extension.
Lower the vehicle.

Fig 5: Installing Right Fender Wheelhouse Extension
Courtesy of GENERAL MOTORS CORP.