LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 513 (Transfer Case - NVG 236/246-NP8 (Two Speed Automatic)) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to JACKING AND LIFTING in General Information.
  2. Remove the transfer case shield from the vehicle. Refer to TRANSFER CASE SHIELD REPLACEMENT  .
    Fig 1: Removing Transfer Case Rear Output Shaft Seal
    G01468411Courtesy of GENERAL MOTORS CORP.
  3. Remove the rear propeller shaft from the transfer case.
    • For vehicles equipped with the one piece rear propeller shaft, refer to PROPELLER SHAFT REPLACEMENT - ONE PIECE in Propeller Shaft.
    • For vehicles equipped with the two piece rear propeller shaft, refer to PROPELLER SHAFT REPLACEMENT - TWO PIECE in Propeller Shaft.
  4. Remove the transfer case rear output shaft seal.
scientia non olet · About LEMON Manuals