LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 513 (Transfer Case - NVG 236/246-NP8 (Two Speed Automatic)) >> Repair Instructions >> Transfer Case Adapter Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

Important:  The following service procedure is for vehicle equipped with AUTOMATIC TRANSMISSIONS ONLY. Vehicle equipped with manual transmissions are NOT equipped with a transfer case adapters.

  1. Remove the transfer case assembly. Refer to TRANSFER CASE ASSEMBLY REPLACEMENT  .
  2. Using a suitable jack stand, support the transmission assembly.
    Fig 1: Removing Transfer Case Assembly
    G01468435Courtesy of GENERAL MOTORS CORP.
  3. Remove the transfer case adapter mounting bolts.
  4. Remove the transfer case adapter.
  5. Remove the transfer case adapter seal.
    Fig 2: Removing Transfer Case Adapter Mounting Bolts
    G01468436Courtesy of GENERAL MOTORS CORP.
  6. Remove the transfer case gasket.
    Fig 3: Removing Transfer Case Gasket
    G01468437Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals