LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 513 (Transfer Case - NVG 236/246-NP8 (Two Speed Automatic)) >> Repair Instructions >> Transfer Case Adapter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Do not reuse the old gasket if it is damaged, replaced it. Do not use any type of sealer in place of the gasket.

  1. Install the new transfer case adapter seal.
  2. Install the transfer adapter.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the transfer case adapter mounting bolts.

    Tighten 

    Tighten the transfer case adapter mounting bolts to 550 N.m (40 lb ft).

    Fig 1: Installing New Transfer Case Adapter Seal
    G01468438Courtesy of GENERAL MOTORS CORP.
  4. Install a new gasket the transfer case gasket.
    Fig 2: Install New Transfer Case Gasket
    G01468439Courtesy of GENERAL MOTORS CORP.
  5. Install the transfer case assembly. Refer to TRANSFER CASE ASSEMBLY REPLACEMENT  .
    Fig 3: Installing Transfer Case Assembly
    G01468440Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals