LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 512 (Transfer Case - NVG 233-NP1 (Two Speed SELECTABLE)) >> Repair Instructions >> Transfer Case Fluid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. In stall the transfer case drain plug.

    Tighten 

    Tighten the transfer case drain plug to 20 N.m (15 lb ft).

  2. Fill the transfer case with the proper amount of approved fluid. Refer to CAPACITIES - APPROXIMATE FLUID  .
    Fig 1: Installing Transfer Case Drain Plug
    G01468255Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the transfer case fill plug.

    Tighten 

    Tighten the oil fill plug to 20 N.m (15 lb ft).

  4. Install the transfer case shield. Refer to TRANSFER CASE SHIELD REPLACEMENT  .
  5. Lower the vehicle. Refer to JACKING AND LIFTING in General Information.
    Fig 2: Installing Transfer Case Fill Plug
    G01468256Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals