LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 510 (Front Drive Axle - 4WD) >> Repair Instructions >> Clutch Shaft Bearing Replacement - Front Drive Axle >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing Clutch Shaft Pilot Bearing
G01468003Courtesy of GENERAL MOTORS CORP.
  1. Remove the inner axle shaft and housing assembly. Refer to INNER SHAFT AND/OR HOUSING REPLACEMENT - FRONT DRIVE AXLE (S4WD)  or INNER SHAFT AND/OR HOUSING REPLACEMENT - FRONT DRIVE AXLE (A4WD)  .
  2. Remove the clutch shaft from the differential carrier assembly.
  3. Remove the clutch shaft pilot bearing using the J 34011  .
    Fig 2: Installing Clutch Shaft Pilot Bearing
    G01468004Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals