LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 510 (Front Drive Axle - 4WD) >> Repair Instructions >> Clutch Fork Replacement - Front Drive Axle >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Installing New Clutch Fork Housing Seal
G01468001Courtesy of GENERAL MOTORS CORP.
  1. Install the new clutch fork housing seal using the J 33799  .
  2. Install the new clutch fork (17) and clutch fork inner spring (16) into the inner axle shaft housing.
  3. Install the clutch cable retainer spring (14) onto the clutch fork (17).
  4. Install the inner axle shaft and housing assembly. Refer to INNER SHAFT AND/OR HOUSING REPLACEMENT - FRONT DRIVE AXLE (S4WD)  or INNER SHAFT AND/OR HOUSING REPLACEMENT - FRONT DRIVE AXLE (A4WD)  .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals