LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 509 (Propeller Shaft And Universal Joints) >> Repair Instructions >> Propeller Shaft Replacement - One Piece >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Slide the propeller shaft into the transmission.

    Important:  Install a new universal joint whenever a slip joint or companion flange is serviced.

  2. Lubricate the slip joint.
  3. Install the yoke to the pinion flange.
  4. Align the reference marks on the pinion flange and the propeller shaft rear yoke. Seat the yoke properly.
  5. Install the retainers.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  6. Install the rear pinion flange bolts into the pinion flange.

    Tighten 

    • Tighten the rear pinion flange bolts to 20 N.m (15 lb ft) for 2.2L engines.
    • Tighten the rear pinion flange bolts to 45 N.m (33 lb ft) for 4.3L engines.
    Fig 1: Installing Rear Pinion Flange Bolts Into Pinion Flange
    G01467841Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals