LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 509 (Propeller Shaft And Universal Joints) >> Repair Instructions >> Propeller Shaft Center Support Bearing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the center bearing (3) onto the propeller shaft (2) by pressing the center bearing onto the shaft using a press (1).

    Ensure that the center bearing is fully seated on the propeller shaft.

  2. Install the propeller shaft. Refer to PROPELLER SHAFT REPLACEMENT - TWO PIECE  .
  3. Lower the vehicle.
    Fig 1: Installing Center Bearing Onto Propeller Shaft By Pressing
    G01467847Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals