LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 504 (Bumper System) >> Repair Instructions >> Impact Bar Replacement - Front Bumper >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front bumper fascia. Refer to FASCIA REPLACEMENT - FRONT BUMPER - UPPER (AZTEK)  or FASCIA REPLACEMENT - FRONT BUMPER - UPPER (RENDEZVOUS)  .
  2. Remove the energy absorber. Refer to ENERGY ABSORBER REPLACEMENT - FRONT (AZTEK)  or ENERGY ABSORBER REPLACEMENT - FRONT (RENDEZVOUS)  .
  3. Remove the bolt from the upper inboard impact bar through the access hole in the radiator support.
    Fig 1: Removing Horns From Impact Bar
    G01515800Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the electrical connector from the horn.
  5. Remove the horns from the impact bar.
    Fig 2: Removing Remainder Of Impact Bar Bolts
    G01515801Courtesy of GENERAL MOTORS CORP.
  6. Remove the remainder of the impact bar bolts.
  7. Remove the impact bar.
    Fig 3: Removing Impact Bar-To-Front Bumper Bolts
    G01515802Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals