Removal Procedure

Important:  Note the following locations:

• The position of the wire harness routing
• The location of the tie-straps that secure the wire harness to the drive cable tube and the sunroof module.

1. Position the sunshade in the full forward position.
2. Remove the headliner. Refer to HEADLINER REPLACEMENT (AZTEK) or HEADLINER REPLACEMENT (RENDEZVOUS) .
3. Cut the nylon tie straps on the sunroof control module and the drive cable tube.
   Fig 1: Cutting Nylon Tie Straps On Sunroof Control Module And Drive Cable Tube

   Courtesy of GENERAL MOTORS CORP.
4. Disconnect the electrical connectors from the following components:
   • The sunroof control switch
   • The sunroof control module
   • The sunroof actuator
   • The sunroof opening position switch
   • The body connector
5. Remove the tape holding the wire harness to the sunroof module.
6. Remove the wire harness from the sunroof.
   Fig 2: Removing Wire Harness From Sunroof

   Courtesy of GENERAL MOTORS CORP.