LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Wheel Alignment Specifications & Adjustment Procedures) >> Wheel Alignment Procedures >> Camber & Caster Adjustment >> "M" & "T" Series (Caster & Camber)

"M" & "T" Series (Caster & Camber)

WARNING: This page does not describe the selected car, but rather 47 other vehicles, including the 2001 Pontiac Montana, 2001 Pontiac Aztek, 2001 Oldsmobile Silhouette, 2001 Oldsmobile Bravada, and 2001 GMC Sonoma. However, it is still accessible from the selected car via links, so may be relevant.

Loosen nut on end of each bolt securing upper control arm to frame brackets. See Figure and Figure . Rotate bolts until camber and caster are within specification. See WHEEL ALIGNMENT SPECIFICATIONS  table. Tighten nuts to specification. See TORQUE SPECIFICATIONS  .

scientia non olet · About LEMON Manuals