"A" & "B" Series (Front & Rear)
WARNING: This page does not describe the selected car, but rather 47 other vehicles, including the 2001 Pontiac Montana, 2001 Pontiac Aztek, 2001 Oldsmobile Silhouette, 2001 Oldsmobile Bravada, and 2001 GMC Sonoma. However, it is still accessible from the selected car via links, so may be relevant.
- Lift front bumper about 1.5" (38 mm). Gently remove hands and allow vehicle to settle on its own. Push front bumper down about 1.5" (38 mm). Gently remove hands and allow vehicle to rise on its own. Measure and record dimension "J" from centerline of front wheel to about 24" (604 mm) of vehicle underbody. See Figure .
- Lift rear bumper about 1.5" (38 mm). Gently remove hands and allow vehicle to settle on its own. Push down on front bumper about 1.5" (38 mm). Gently remove hands and allow vehicle to settle on its own. Measure and record dimension "K" from centerline of rear wheel to about 22" (560 mm) of vehicle underbody. See Figure .
- Lift front bumper up about 1.5" (38 mm). Gently remove hands to allow vehicle to settle on its own. Push down on front bumper about 1.5" (38 mm). Gently remove hands to allow vehicle to settle on its own. Measure and record dimension "Z". See Figure .
- Lift rear bumper up about 1.5" (38 mm). Gently remove hands to allow vehicle to settle on its own. Push down on rear bumper about 1.5" (38 mm). Gently remove hands to allow vehicle to settle on its own. Measure and record dimension "D". See Figure . If ride height is not as specified, repair or replace suspension components as necessary. See RIDE HEIGHT SPECIFICATIONS table. If ride height is okay, align wheels. See WHEEL ALIGNMENT PROCEDURES