LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 498 (Body Rear End) >> Repair Instructions >> Water Deflector Replacement - End Gate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the endgate door water deflector to the endgate inner panel.
  2. Secure the water deflector at the corners.
  3. Starting at the bottom center, press the adhesive outward and upward to prevent puckering.
  4. Install the endgate trim panel. Refer to TRIM PANEL REPLACEMENT - END GATE  .
    Fig 1: Installing Procedure Water Deflector Replacement - End Gate
    G01518404Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals