LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 498 (Body Rear End) >> Repair Instructions >> Trim Panel Replacement - End Gate >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the endgate.
  2. Remove the endgate inside handle from the endgate. Refer to HANDLE REPLACEMENT - END GATE  .
  3. Remove the endgate trim panel from the endgate inner panel using J 38778. 
    Fig 1: Removing Procedure Trim Panel Replacement - End Gate
    G01518393Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals