LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 498 (Body Rear End) >> Repair Instructions >> Spoiler Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Do not touch the adhesive backing.

  1. Remove the backing tape from the underside of the spoiler.
  2. Install the rear spoiler to the liftgate, pressing into place until the adhesive is fully seated.
  3. Install the nuts to the rear liftgate spoiler.

    Tighten the rear liftgate spoiler nuts to 6 N.m (53 lb in).

  4. Install the rear liftgate spoiler water channel.
  5. Install the liftgate trim. Refer to TRIM PANEL REPLACEMENT - LIFT GATE (AZTEK)  or TRIM PANEL REPLACEMENT - LIFT GATE (RENDEZVOUS)  .
    Fig 1: Installing Procedure Spoiler Replacement - Rear
    G01518414Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals