LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 498 (Body Rear End) >> Repair Instructions >> Opening The Lift Gate When There Is An Electrical Failure (Aztec)

Opening The Lift Gate When There Is An Electrical Failure (Aztec)

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the rear door.
  2. Remove the rear seats. Refer to SEAT REPLACEMENT -- REAR 50-50 SPLIT or SEAT REPLACEMENT -- BUCKET .
  3. Mark the location on each side of the endgate trim panel for the holes to be drilled using the following dimensions:
    • Dimension (a) is 63 mm (2.5 in.) from the feature line on the endgate trim panel.
    • Dimension (b) is 114 mm (4.5 in.) from the edge of the endgate trim panel.
  4. Drill a hole at the marked locations using a 22 mm (.875 in) drill bit.
  5. Insert a flat bladed tool in to the access hole and rotate the endgate latch clockwise to release.
    Fig 1: Lift Gate Opening Procedure Electrical Failure (Aztec - 1 Of 2)
    G01518383Courtesy of GENERAL MOTORS CORP.
  6. Open the liftgate.
  7. Open the endgate.
  8. Plug the access holes using GM P/N 88954014.
  9. If necessary, paint to match.
    Fig 2: Lift Gate Opening Procedure Electrical Failure (Aztec - 2 Of 2)
    G01518384Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals