LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 498 (Body Rear End) >> Repair Instructions >> Lock Cylinder Replacement - End Gate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the endgate lock cylinder to the endgate.
  2. Install the endgate lock cylinder retainer to the lock cylinder, pressing into place until fully seated.
  3. Connect the electrical connector to the endgate lock cylinder.
  4. Connect the endgate lock cylinder wiring harness to the endgate inner panel.
  5. Install the endgate water deflector. Refer to WATER DEFLECTOR REPLACEMENT - END GATE  .
  6. Install the endgate trim panel. Refer to TRIM PANEL REPLACEMENT - END GATE  .
  7. Close the endgate.
    Fig 1: Installing Endgate Lock Cylinder To Endgate
    G01518470Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals