LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 498 (Body Rear End) >> Repair Instructions >> Lift Gate Applique Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the locking tabs on the lift gate trim panel access panel and remove the access panel.
  2. Remove the wing nuts from the studs on the lift gate applique.
  3. Remove the lift gate applique nuts.
  4. Partially remove the lift gate applique to access the electrical connector.
  5. Disconnect the lift gate applique electrical connector.
  6. Remove the lift gate applique.
    Fig 1: Removing Procedure Lift Gate Applique (1 Of 2)
    G01518407Courtesy of GENERAL MOTORS CORP.
  7. Remove the license plate lamp sockets from the lift gate applique.
  8. Remove the lift gate applique lamp sockets from the lift gate applique.
  9. Remove the backup lamp sockets and harness from the lift gate applique.
    Fig 2: Removing Procedure Lift Gate Applique (2 Of 2)
    G01518408Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals