LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 498 (Body Rear End) >> Repair Instructions >> Latch Replacement - Lift Gate (Aztec) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the endgate.
  2. Remove the endgate trim panel. Refer to TRIM PANEL REPLACEMENT - END GATE  .
  3. Disconnect the electrical connectors from the liftgate latches.
    Fig 1: Disconnecting Electrical Connectors From Liftgate Latches
    G01518385Courtesy of GENERAL MOTORS CORP.
  4. Remove the bolts from the liftgate latches.
    Fig 2: Removing Bolts From Liftgate Latches
    G01518386Courtesy of GENERAL MOTORS CORP.
  5. Remove the liftgate latches from the endgate.
    Fig 3: Removing Liftgate Latches From Endgate
    G01518387Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals