LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 495 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Rear Upper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear seat belt to the slot in the rear roof garnish molding.
  2. Connect the electrical connector to the rear cargo lamp.
    Fig 1: Installing Procedure Of Garnish Molding - Rear Upper (1 Of 2)
    G01518320Courtesy of GENERAL MOTORS CORP.
  3. Install the seat belt escutcheon to the rear roof garnish molding.
  4. Install the push-in retainers to the rear roof garnish molding, applying pressure on the molding to secure at all retainer locations.
    Fig 2: Installing Procedure Of Garnish Molding - Rear Upper (2 Of 2)
    G01518321Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals