LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 492 (Wiper System & Washer System) >> Repair Instructions >> Wiper Arm Blade Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the ACCY position.
  2. Turn the wiper switch to the DELAY position.
  3. Turn the ignition OFF when the wipers are in the innerwipe position and not moving.
  4. Push in the button of the wiper blade clip and remove the wiper blade from the inside radius of the wiper arm.
    Fig 1: Pushing Button Of Wiper Blade Clip For Wiper Blade Removal
    G01517347Courtesy of GENERAL MOTORS CORP.
  5. Bring the wiper arm out through the opening in the wiper blade.
    Fig 2: Bringing Wiper Arm Out
    G01517348Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals