LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 491 (Seat System) >> Repair Instructions >> Lumbar Adjuster Plate Replacement - Manual >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the lumbar control to the seat cushion frame.
  2. Install the screws to the lumbar control.

    Tighten 

    Tighten the screws to 10 N.m (89 lb in).

    Fig 1: Installing Screws To Lumbar Control
    G01518093Courtesy of GENERAL MOTORS CORP.
  3. Install the lumbar control cable to the lumbar control.
  4. Install the outer trim panel. Refer to SEAT CUSHION OUTER TRIM PANEL REPLACEMENT - FRONT SEAT  .
  5. Install the front bucket seat. Refer to SEAT REPLACEMENT - BUCKET  .
    Fig 2: Installing Lumbar Control Cable To Lumbar Control
    G01518094Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals