LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 490 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Trim Plate Replacement - Instrument Panel (I/P) Accessory (Aztek) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the retainers on the I/P accessory trim plate to the slots in the I/P.
  2. Install the retainers into the slots until the retainers are fully seated.
  3. Install the 2 screws to the lower trim plate.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

  4. Install the front floor console. Refer to TRIM PLATE REPLACEMENT - FRONT FLOOR CONSOLE (AZTEK)  or TRIM PLATE REPLACEMENT - FRONT FLOOR CONSOLE (RENDEZVOUS)  .
    Fig 1: Installing Instrument Panel Accessory Trim Plate
    G01517703Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals