LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 490 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Aztek) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the knee bolster panel. Refer to KNEE BOLSTER REPLACEMENT  .
  2. Remove the screws from the I/P cluster trim plate at the assist handle.
  3. Pull out the I/P cluster trim plate in order to release from the retainers.
    Fig 1: Removing Screws From I/P Cluster Trim Plate
    G01517704Courtesy of GENERAL MOTORS CORP.
  4. From the back side disconnect the driver information center (DIC) from the I/P cluster trim plate panel.
  5. Loosen the steering column bracket and lower the steering column.
  6. Remove the I/P cluster trim plate.
    Fig 2: Removing I/P Cluster Trim Plate
    G01517705Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals