LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 490 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Knee Bolster Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the IP insulator. Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT - RIGHT  and CLOSEOUT/INSULATOR PANEL REPLACEMENT - LEFT  .
  2. Remove the bolts from the bottom of the knee bolster.
  3. Pull on the knee bolster in order to release the upper clips.
    Fig 1: Removing Knee Bolster
    G01517700Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals