LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 490 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Instrument Panel Cluster (IPC) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connectors to the I/P cluster.
  2. Install the I/P cluster.
  3. Install the screws to the I/P cluster.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

  4. Install the I/P cluster trim plat bezel. Refer to TRIM PLATE BEZEL REPLACEMENT - INSTRUMENT PANEL (I/P) CLUSTER (AZTEK)  or TRIM PLATE BEZEL REPLACEMENT - INSTRUMENT PANEL (I/P) CLUSTER (RENDEZVOUS)  .
  5. Calibrate the electronic compass. Refer to ELECTRONIC COMPASS CALIBRATION  .
    Fig 1: Installing I/P Cluster
    G01517745Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals