LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 484 (Automatic Transaxle Diagnosis, Service & Repair - 4T65-E) >> Repair Instructions >> Front Wheel Drive Shaft Oil Seal Replacement - Right >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the right front tire and wheel assembly.
  3. Remove the right engine splash shield. Refer to SPLASH SHIELD REPLACEMENT -- ENGINE .
  4. Remove the right stabilizer shaft brackets from the right lower control arm. Refer to STABILIZER SHAFT LINK REPLACEMENT .
  5. Remove the right tie rod end from the right steering knuckle. Refer to TIE ROD END REPLACEMENT - OUTER .
  6. Remove the right lower ball joint from the lower control arm. Refer to LOWER BALL JOINT REPLACEMENT .
  7. Remove the right wheel drive shaft from the transaxle. Refer to AXLE SHAFT .
  8. Secure the right wheel drive shaft to the right steering knuckle and strut.
  9. Using the J 6125-B  with the J 6125-1B  and the J 23129  remove the wheel drive shaft oil seal (1) from the transmission.
    Fig 1: Removing Front Wheel Drive Shaft Oil Seal (Right)
    G01501944Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals