LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 484 (Automatic Transaxle Diagnosis, Service & Repair - 4T65-E) >> Repair Instructions >> Automatic Transmission Range Selector Cable Lever Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the throttle body air inlet duct.
  2. Remove the automatic transaxle range selector lever cable from the automatic transaxle range selector lever.
    Fig 1: Removing Automatic Transmission Range Selector Cable Lever (1 Of 2)
    G01501911Courtesy of GENERAL MOTORS CORP.
  3. Remove the automatic transaxle range selector lever retaining nut.
  4. Remove the automatic transaxle range selector lever from the automatic transaxle.
    Fig 2: Removing Automatic Transmission Range Selector Cable Lever (2 Of 2)
    G01501912Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals